BEC Complete TRX-4 TRX-6 Traxxas
- 40.49€
- Disponibilidade: Em Stock
- Fabricante: Traxxas
- Código do produto: 2262
Inclui:
Battery Eliminator Circuit (BEC)
Receiver box cover
Bind plug
Wire clamp
O-ring
Foam pads (3)
Y-harness
2.5x8mmCS(2)
Silicone grease
Zip tie (1)
Características:
BEC é um regulador de voltagem que permite alimentar o recetor a uma voltagem estável, neste caso de 6V;
Evitando picos de tensão que por vezes queimam o recetor e outros componentes;
Este BEC deve ser usado em combinação com um ESC Traxxas com cabo de alimentação externo;
O BEC é conectado entre o ESC e o Recetor. Assim não irá mais conectar o ESC ao canal 2 de seu Recetor, mas conecta o ESC a este BEC, e este BEC ao Recetor.
Irá conectar o BEC ao fio vermelho que sai do ESC, para que o BEC possa fornecer uma voltagem de 6.0V estabilizada, diretamente da bateria para o Recetor, em vez do BEC interno do ESC. Isso significa que ele faz um bypass o BEC interno no ESC. Isto poderá ser util quando necessita de fornecer energia suficiente para alimentar todos os leds, guinchos, e outros componentes eletrónicos e por vezes o BEC interno do ESC não é o suficiente.
Informação adicional da marca:
BEC Installation:
Remove the three 3x8mm BCS from the existing receiver box cover; remove the cover.
Peel the backing from the “L” shaped foam pad and secure it the smooth surface portion on the bottom of the BEC.
Remove the backing from the other side of the foam pad and install the BEC onto the receiver as shown. Install the new o-ring seal on the receiver box. Ensure that the o-ring is properly seated in the groove.
Route the BEC power wire through the new receiver box cover.
Loosen the screws in the battery tray. Lift the battery tray and route the BEC
power wire under the battery tray and over to the electronic speed control
(ESC) (see Wiring Diagram).
Remove the existing zip tie, and then use the included zip tie to secure the
wires to the transmission housing. Note: Ensure that no wires are pinched
before retightening the screws in the battery tray.
Loosen the screws in the ESC and route the BEC power wire behind and
under the ESC (see Wiring Diagram). Retighten the screws. Plug the red female connector from the BEC power wire into the red male connector from the ESC. Note: Use the supplied “Y” harness if another accessory is already plugged into the ESC.
Unplug the ESC connector from Channel 2 of the receiver; plug the connector into the BEC.
Plug the black connector from the BEC into Channel 2 of the receiver.
Install the remaining foam pads on the new receiver box cover and wire clamp.
Apply a small bead of the supplied silicone grease to the foam pads.
Install the new receiver box cover using the 3x8mm BCS.
Place the BEC wire in the wire guide of the receiver box cover and install
the wire clamp using the included 2.5x8 mm CS. Install the bind plug in the receiver box cover.
Nota: Este artigo é contra-indicado para crianças com menos de 3 anos.
